General discussions about our craft and industry.
  • User avatar
  • User avatar
  • User avatar
By Rug Dr.
#15977
Any one here use a seger? I played with one for a few hours yesturday, it was and older juki, it was one fast slick machine.
Last edited by Rug Dr. on Wed Feb 08, 2023 2:28 am, edited 1 time in total.
User avatar
By LLeeT
#15978
I use one on some fabrics on chairs. Most of my work is with vinyls. They are pretty neat machines for sure.
User avatar
By Rhonda
#15985
I been looking for a good one! I here the Juki or the Jerome are good!
By Rug Dr.
#16037
At a minimum you would want a model with a knee lift. A real one with a table and servo is where it's at. Used a juki MO 2500 model again today.
User avatar
By Adam12
#16049
Don't have one of my own but i did get to set up a 3 thread for a customer this week. Lot of fun to play with, stupid fast and buttery smooth. Don't have much use for a serger...but i need one :grin:
Rug Dr. liked this
By MalcolmM
#16070
I bought a 3 thread inexpensive one and it's been good for my needs when working with coarse woven fabric that doesn't have a back coating. I only use it for overcasting edges not for construction which is common for garment sewing.
Rug Dr., Rhonda liked this

I agree it's usually not a problem but on occasion[…]

Single Faced Basting Tape

Thanks Ron. I was watching a video from Cechaflo […]

Do you have a picture of the corner? Trying to und[…]

The Padded Cell

nice job! :grin: