General discussions about our craft and industry.
  • User avatar
  • User avatar
  • User avatar
By Rug Dr.
#15977
Any one here use a seger? I played with one for a few hours yesturday, it was and older juki, it was one fast slick machine.
Last edited by Rug Dr. on Wed Feb 08, 2023 2:28 am, edited 1 time in total.
User avatar
By LLeeT
#15978
I use one on some fabrics on chairs. Most of my work is with vinyls. They are pretty neat machines for sure.
User avatar
By Rhonda
#15985
I been looking for a good one! I here the Juki or the Jerome are good!
By Rug Dr.
#16037
At a minimum you would want a model with a knee lift. A real one with a table and servo is where it's at. Used a juki MO 2500 model again today.
User avatar
By Adam12
#16049
Don't have one of my own but i did get to set up a 3 thread for a customer this week. Lot of fun to play with, stupid fast and buttery smooth. Don't have much use for a serger...but i need one :grin:
Rug Dr. liked this
By MalcolmM
#16070
I bought a 3 thread inexpensive one and it's been good for my needs when working with coarse woven fabric that doesn't have a back coating. I only use it for overcasting edges not for construction which is common for garment sewing.
Rug Dr., Rhonda liked this
Single Faced Basting Tape

Drop the single face and just enter basting tape. […]

I have a Pfaff 545 and 1245 which use the same bob[…]

Do you have a picture of the corner? Trying to und[…]

The Padded Cell

nice job! :grin: