- Sat May 07, 2022 2:33 pm
#15077
Hi. I have a set of dining room chairs that I'm seeking advise/tips how to upholster the backs. The current backs are a 1/8" bending plywood, covered with foam batting that is attached to the chair using brads. I see the backs cover the screws that are used to attach the front upholstery, that is stretched over a thicker foam and the same 1/8" bendable plywood. My goal is to re-upholster these chairs with vinyl.
Pictures of the back and side are attached... I hope this provides enough information, if not, pls let me know.
Thanks!
Pictures of the back and side are attached... I hope this provides enough information, if not, pls let me know.
Thanks!
Attachments
side view
tempImageeFTR9f.gif (5.88 MiB) Viewed 1827 times
tempImageeFTR9f.gif (5.88 MiB) Viewed 1827 times
seat back
tempImage3EWG4F.gif (6.42 MiB) Viewed 1827 times
tempImage3EWG4F.gif (6.42 MiB) Viewed 1827 times
WM