• User avatar
  • User avatar
#11966
I bought a used office chair, but the seat sinks a bit too much when I sit in it. The seat uses zig zag springs. Is there a way to make this seat more firm?

UPDATE: Having taken the bottom cover off and looking more closely, there is a twine cord which has snapped (image attached). Any suggestions for replacing this (where to get materials and technique)?
Attachments
x.jpg
x.jpg (163.8 KiB) Viewed 3016 times
#12096
nims wrote: Sat Dec 19, 2020 6:08 pm I bought a used office chair, but the seat sinks a bit too much when I sit in it. The seat uses zig zag springs. Is there a way to make this seat more firm?

UPDATE: Having taken the bottom cover off and looking more closely, there is a twine cord which has snapped (image attached). Any suggestions for replacing this (where to get materials and technique)?
Not sure if you've already fixed this, but I recommend weaving some webbing between the springs. Using wire may be too rigid. With webbing you have way more control over how much bounce you get by choosing the amount of stretch in the webbing, jute being the most rigid. It's also adds more support to the springs and structure of the chair. :)
John, Revv Up liked this

With a vision to empower and inspire our customers[…]

First Project - Cube Stool

Sleek contemporary furniture combined with a neutr[…]

I agree it's usually not a problem but on occasion[…]

Single Faced Basting Tape

Thanks Ron. I was watching a video from Cechaflo […]